Wireless Network Projection
• For infrastructure mode, set the Simple AP setting to Off and go to
next step.
• If you installed the optional wireless LAN module and want to use both
connection methods at the same time, set the Simple AP setting to On
and go to next step.
h
Select the Wireless LAN menu and press [Enter].
The projector starts searching for access points.
You can also search for access points using the Search Access Point
setting manually. See the Specifications for details on the supported
channels.
i
Select the access point you want to connect to.
If you need to assign the SSID manually, select SSID to enter the
SSID.
j
Assign the IP settings for your network as necessary.
• If your network assigns addresses automatically, select IP Settings to set
the DHCP setting to On.
• If you must set addresses manually, select IP Settings to set the DHCP
setting to Off, and then enter the projector's IP Address, Subnet Mask,
and Gateway Address as necessary.
k
To prevent the IP address from being displayed on the network
information screen, set the IP Address Display setting to Off.
145