Input Signal Settings - Signal I/O Menu - Epson EB-810E User Manual

Input Signal Settings - Signal I/O Menu

Setting Options
Dynamic Range Dynamic Range
Signal Status
HDR10 Setting
HLG Setting
Reset to Defaults —
Description
Changes the range of dark and bright
areas in images; choose from Auto
(recommended), SDR, HDR10, or HLG.
Setting is only displayed in the following
cases:
• Color Mode is not set to DICOM
SIM.
• The current source is HDMI or
HDBaseT.
Displays the detected input image signal.
Changes the PQ (Perceptual Quantizer)
curve of the dynamic range using the
HDR PQ method.
This setting is only displayed when
Dynamic Range is set to Auto and Signal
Status is HDR10, or when Dynamic
Range is set to HDR10.
Changes the HLG (Hybrid Log Gamma)
curve of the dynamic range using the
HDR HLG method.
This setting is only displayed when
Dynamic Range is set to Auto and Signal
Status is HLG, or when Dynamic Range
is set to HLG.
Resets all settings for current input
source.
Setting Options
EDID EDID (HDMI1)
EDID (HDMI2)
EDID (HDBaseT)
HDMI IN EQ Level HDMI1
HDMI2
A/V Output While Projecting
Always On
Inverse Audio On
Off
Description
Describes the display capabilities of
your projector. Change this setting as
necessary according to the resolution of
the image.
You can select the EDID settings
for individual input sources without
changing the input source.
Adjusts the HDMI input signal level
depending on the devices connected to
the HDMI port. If there is a lot of
interference in the image, or if a problem
such as no image being projected occurs,
change the setting.
You can select the settings for individual
input sources without changing the input
source.
Set to Always On to output audio from
the projector's speaker system when the
projector does not project any images.
Setting is only displayed in the following
cases:
• Auto Power On is set to HDMI1 and
Power On Trigger is set to Plug-in
Detection.
• Quick Startup is set to Off in the
projector's Operation menu.
• Auto Power On is set to Off in the
projector's Network menu.
Network > Transmitter Settings >
s
Auto Power On
Set to On to invert the audio's left and
right channels to match the projector
installation position.
193