Gear Reducer - Vulcan-Hart VG30 Service Manual

GAS BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
7. To install:
A. With drive key on shaft, install motor to

gear reducer.

B. Route and secure the motors' power cable
and re-connect motor lead wires.
C. Replace power supply box cover and side
panels.
8. Check for proper operation.
GEAR REDUCER
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove right side and rear panels as outlined
under COVERS AND PANELS.
2. Lower the pan (use motorized pan lift or manual
crank).
3. If DC lift motor is installed, remove motor as
outlined under DC LIFT MOTOR.
4. Remove lock nut securing crank assembly to lift
arm.
5. Remove bolts securing gear reducer to braising
pan frame then remove gear reducer.
F25121 (February 2003)
6. Loosen set screw on crank assembly and
remove the assembly from drive shaft.
7. Loosen set screw on shaft extension coupling
and remove the coupling from manual crank
shaft.
8. To install:
A. With drive key on drive shaft, install crank
assembly and tighten set screw against
key.
B. With drive key on manual crank shaft,
install shaft extension coupling and tighten
set screw against key.
C. Place gear reducer in its mounting location
on frame. Position gear reducer so the
shaft extension coupling is aligned with the
opening in control panel; and the lift arm is
vertical and parallel to the crank assembly
when connected.
Page 10 of 32