Page 1
Reproduction or other use of this Manual, without the express written consent of Vulcan, is prohibited. VULCAN-HART 3600 NORTH POINT BLDV. DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC BALTIMORE, MD 21222 WWW.VULCANHART.COM...
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. READ THIS MANUAL THOROUGHLY BEFORE OPERATING, INSTALLING OR PERFORMING MAINTENANCE ON THE EQUIPMENT.
Manual for detailed cleaning instructions. rivets Models VHFA9 VHFA18. ELECTRICAL REQUIREMENTS Special • Treatment remove All Vulcan-Hart 110/120 volt cabinets are equipped with an 8 ft. (2.4m) cord and Calcium/Lime/Rust from cabinet. (Contact Authorized Vulcan-Hart NEMA 5-15 or 5-20 plug as standard Servicer.) equipment.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) MODELS: VHFA9, VHFA18 CONTROLS FAN - FRONT VIEW CONTROL - FRONT VIEW (5) FAN MOUNTING PLATE SCREWS THERMOMETER DIAL THERMOSTAT POWER ON/OFF SWITCH POWER INDICATOR LIGHT HEAT INDICATOR LIGHT Fig. 7 (4) FAN ATTACHING SCREWS Fig.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) MODELS: VHFA9, VHFA18 (continued) PROBE THERMOSTAT: Monitors/sensors output temperature of the heating elements. Once the output temperature of the heating The fan is located on top of the unit. The element reaches the set temperature, the fan and air tunnel provide even heat thermostat sensor removes power from the...
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) COMPONENT REMOVAL AND REPLACEMENT COVER REMOVAL The Cover must be removed to access the Thermostat, Thermometer, Lights, and Wiring. SCREWS ACCESS HOLE Fig. 13 Locate and remove the two (2) screws holding the top cover to the left side.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) Remove the two (2) screws on THERMOSTAT the front of the control panel that hold the thermostat in place and remove the thermostat. Install replacement thermostat temperature sensing probe by reversing the steps Remove the Cover.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) Replace knob and tighten set screws. VHFA9, VHFA18 Reconnect the cabinet to its power source and test. DUAL LIGHT INDICATOR Remove the five (5) screws from the fan mounting plate. (Fig. 10) Unplug the fan power cord.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) Remove the bottom mounted ON / OFF SWITCH element cover. VHFA9, VHFA18 Remove the two (2) retaining screws that hold each element to the mounting plate and the one (1) screw for the element clip. (Fig.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) LEAD WIRES LEAD CONNECTORS Install the replacement cord by inserting the cord and threaded portion of the strain relief through the opening in the cover. Complete installation reversing the above steps. Reconnect the cabinet to its Fig.
SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Vulcan-Hart Service Department at the address listed on the front cover of this manual or refer to our website: www.vulcanhart.com a complete listing of Authorized Service and Parts depots.
V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09) TROUBLESHOOTING SYMPTOMS POSSIBLE CAUSES REMEDY Cabinet not Cabinet not connected Connect cabinet to power source. operating. to power source. Cabinet lighted power Turn lighted power switch ON. switch not turned ON. No power.