Yamaha QX5 Owner's Manual page 14

13
MEASURE
Measure Memory
TRACK
NOTE i
aaa
If Clock is set to MIDI or TAPE (see p. 14), you will not be able to change
the tempo. It will only be displayed. If there is no MIDI clock producing device
connected, or if the tape is stopped, the displayed tempo will be 0.
TEMPO=000 TEMPO=000
x MIDI CLOCK x * TAPE CLOCK x
Press [MEASURE] and use and to move backward or forward. [FT] will
take you to measure 1 (the beginning of the song) and will move to the be-
ginning of the current measure (beat 1).
Beat
Measure
MEASURE=0027-01
0001-01 Back Fwd
If you are at beat 100 or beyond, the display will show the last two places. (It is
possible, though unusual, to have more than 100 beats in a measure.) If more than
one track is on, the measure marks of the lowest-numbered
track will be used.
(It is possible to have different time signatures for different points in each track.
See Beat/Measure, p.38.)
You can preset three different measure numbers and jump to them instantly. Press
[SHIFT] and the display will show the three preset measures. Press [F2]-[F4] to
jump to the preset measure. To change the measure memories, move to the measure
you want to save using [F3] and [F4], then press [F1] while holding [SHIFT].
The "S" of "Save" will begin blinking. Press [F2]-[F4] to save the current measure
position in a preset. If the measure position is 999 or above, it will be displayed
as 999.
MEASURE=0027-01
Save 121 015 105
SHIFT
Cl A A A A
The measure memory is used in Auto Locate (p. 16), and and measure
memories are used in Punch In (p. 16).
Each of the 8 tracks can be set to Off, Muted, or On. Press [TRACK] and use
[Fi] - [F4] to switch tracks 1-4. Pressing [F1] - [F4] while holding [SHIFT] will switch
tracks 5-8.
(d