Other Functions - Yamaha Rio3224-D2 Owner's Manual

Display Operations

Other functions

Initializing to the factory-set state
If you turn on the power while holding down both the  (DEC) button and  (INC) button, you can enter a mode that
returns this unit's settings to their factory-set state. This is the same as if you use the SETUP menu to select INITIALIZE
→ FACTORY PRESET.
Initializing the HA parameters
If you turn on the power while holding down only the  (DEC) button, you will enter a mode that returns the HA
parameter values to their factory-set state.
This is the same as if you use the SETUP menu to select INITIALIZE → HA PARAMETERS.
Initializing the Dante parameters
If you turn on the power while holding down only the  (INC) button, you will enter a mode that returns the Dante
parameter values to their factory-set state. This is the same as if you use the SETUP menu to select INITIALIZE →
DANTE SETTINGS.
Factory-set initial values
The following table shows the factory-set initial values.
SETUP
HA Parameters
DANTE Settings
*1 nnnnnn is the lowest six digits of the Dante Primary MAC Address
Panel lock
While this unit is operating, you can put it in the panel lock state by simultaneously holding down the  (DEC) button,
 (INC) button, and the encoder with switch for approximately three seconds. This state is maintained even if the unit
is power-cycled. To defeat the panel lock state, simultaneously hold down the  (DEC) button,  (INC) button, and the
encoder with switch once again for approximately three seconds.
Brightness adjustment
While this unit is operating, simultaneously hold down the  (DEC) button and  (INC) button for at least 1.5 seconds,
and turn the encoder with switch to adjust the brightness of the display (BRIGHTNESS).
22
Parameter
UNIT ID
START UP MODE
SECONDARY PORT
FAN SPEED
NETWORK MODE
IP ADDRESS
SUBNET MASK
DEFAULT GW
DIMMER
ERROR MESSAGE
BRIGHTNESS
HA GAIN
+48V
HPF
GAIN COMPENSATION
Sample Rate
Latency
Encoding
Dante Redundancy
IP Address
Device Label
Channel Label
AES67 Mode
Device Lock
Owner's Manual
Initial value
Y001
REFRESH
DAISY CHAIN
LOW
AUTO
(determined by DHCP or link local)
(determined by DHCP or link local)
(determined by DHCP or link local)
3 min
LIGHT OFF
70%
–6 dB
Off
Off, 80.0 Hz
Off, –6 dB
96 kHz (slave), Pull-up/down = None
1.0 ms
PCM 24 bit
Switched (depends on the setting of SETUP  SECONDARY PORT)
Auto
Y001-Yamaha-Rio3224-D2-nnnnnn *1
Y001-Yamaha-Rio1608-D2-nnnnnn *1
<channel number>
Disabled
Unlock