Heat & Glo TRUE-36G-IFT Installation Manual page 64

Log Set Assembly: LOGS-TRUE50-HD
Models: TRUE-50C, TRUE-50H, TRUE-50S
TRUE-50H-IFT, TRUE-50S-IFT, TRUE-50TG-IFT
CAUTION: Logs are fragile, handle with care.
7 7
2 2
1 1
Log #1 (SRV2282-741): Locate log placement notch on the bottom of Log #1. See Figure 2. Mate outer notches on the
bottom of Log #1 with the log placement tabs. Slide Log #1 toward the rear of appliance until back side of Log #1 contacts
the log placement tabs shown in Figure 1 and then slide it to the left until it contacts the left rear grate tine. See Figure 3.
NOTCH FOR LOG #6 NOTCH FOR LOG #6
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
Figure 2
Log #2 (SRV2282-742): Locate log placement notches on the bottom of Log #2. See Figure 4. Mate notches on the bottom
of Log #2 as shown in Figure 5. Notch on front of log will contact right front grate tine and notch on right side of log will
contact the side grate tine. Left end of Log #2 will contact the center log placement tab. See Figure 1.
NOTCH FOR NOTCH FOR
BURNED AREA BURNED AREA
LOG #4 LOG #4
NOTCH NOTCH
Figure 4
64 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
9 9
8 8
3 3 6 6
4 4 5 5
NOTCH FOR LOG #3 NOTCH FOR LOG #3
1 1
2 2
3 3
NOTCH NOTCH
LOG PLACEMENT INSTRUCTIONS
LOG PLACEMENT TABS LOG PLACEMENT TABS
CENTER LOG PLACEMENT TAB CENTER LOG PLACEMENT TAB
Figure 1
1 1
Figure 3
NOTCH FOR NOTCH FOR
LOG #3 LOG #3
NOTCH FOR NOTCH FOR
LOG #4 LOG #4
LOG RESTING LOG RESTING
AREA FOR LOG #3 AREA FOR LOG #3
Figure 5
LOG CONTACTS LOG CONTACTS
1 1
GRATE TINE GRATE TINE
2 2
LOG CONTACTS LOG CONTACTS
GRATE TINE GRATE TINE