Heat & Glo TRUE-36G-IFT Installation Manual page 65

1 1
FLAT AREA FOR LOG #5 FLAT AREA FOR LOG #5
LOG NOTCH LOG NOTCH
LOG RESTS ON REFRACTORY LOG RESTS ON REFRACTORY
CONTACTS CONTACTS
LEFT GRATE LEFT GRATE
TINE TINE
Figure 6
Log #4 (SRV2282-744):
refractory. Notch on Log #4, shown in Figure 7, will rest on the front left grate tine and the top of log will rest in notch on
Log #2. See Figure 6.
Log #3 (SRV2282-743): Locate log placement areas for Log #3. See Figure 5. Place Log #3 into notch on Log #1 so
that the base rests on the 昀氀at area of Log #2. The top of the burned area on Log #3 will be close to Log #1 when properly
positioned. See Figure 8.
TOP OF BURNED TOP OF BURNED
AREA NEAR LOG #1 AREA NEAR LOG #1
1 1
2 2
LOG PLACED IN LOG LOG PLACED IN LOG
RESTING AREA RESTING AREA
Figure 8
Log #5 (SRV2281-745): Locate 昀氀at area on Log #4 that will be used to position Log #5. See Figure 6. Place Log #5 into
appliance as shown in Figure 9. The left side of the log will rest on bottom refractory and pilot bracket. It will also lean
against the rear grate tine. The right side of Log #5 will rest in the notch on Log #4. There will be a space approximately 1
inch from the end of the log to the left side refractory.
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
LOG RESTS ON LOG #2 LOG RESTS ON LOG #2
4 4
2 2
Place Log #4 between the left and center grate tines. The base of Log #4 should rest on the
3 3
4 4
NOTCH NOTCH
Figure 7
LOG RESTS ON PILOT LOG RESTS ON PILOT
BRACKET AND LEANS BRACKET AND LEANS
AGAINST REAR GRATE AGAINST REAR GRATE
TINE TINE
LOG RESTS ON LOG #4 LOG RESTS ON LOG #4
1 IN. 1 IN.
5 5
4 4
LOG RESTS ON BOTTOM REFRACTORY LOG RESTS ON BOTTOM REFRACTORY
Figure 9
1 1
2 2
65