Install The Refractory (Exclaim-42 Only) - Heat & Glo Exclaim-36 Installation Manual

C. Install the Refractory (Exclaim-42 only)
We recommend two installers for hearth stone and refrac-
tory installation!
Note: Before installing refractories and hearth stone, be
sure all back edges of each piece are smooth to ensure
proper fit. Scrape away excess with a regular screwdriver.
See Figure 8.2.
Figure 8.2 Scrape Away Rough Edges
• Set back refractory into place, making sure refractory is
centered and notches are to the bottom of firebox.
• Place grate brackets in outer two notches of refractory.
See Figure 8.3.
• Secure back refractory in place with a screw and bracket
supplied in hardware package. See Figure 8.4.
GRATE BRACKETS
Figure 8.3 Back Refractory with Grate Brackets in Place
Figure 8.4 Attaching Back Refractory
36 Heat & Glo • Exclaim 36/42 • 4013-266 Installers Manual • Rev G • 10/07/13
REFRACTORY
BRACKET
Note:
To ensure proper installation, gas knockouts in the side
refractory should be positioned towards back of fireplace. See
Figure 8.5.
GAS
KNOCKOUT
Figure 8.5 Gas Knockout
• Tilt top of side refractory towards center of firebox when
placing it into fireplace. Push side refractory towards
back corner of fireplace until it fits tightly against back
refractory.
• Secure side refractory in place with a screw and bracket
provided in the hardware package.
• Repeat these two steps for installation of the other side
refractory.
• When placing hearth stone into fireplace, slide it back
until it fits tightly against back refractory (underneath
grate brackets). See Figure 8.6.
GRATE
BRACKET
Figure 8.6 Sliding Bottom Refractory Towards
Back of Fireplace
• Place grate into grate brackets. See Figure 8.7.
• Replace smoke shield.
GRATE
BRACKET
Figure 8.7 Grate Secured in Grate Bracket
• Replace left and right screens.