Standard Oven Control Valve/Thermocouple; Model 36 Only - Vulcan-Hart G260 Service Manual

ENDURANCE SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS
STANDARD OVEN CONTROL
VALVE/THERMOCOUPLE
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
Model 36
The oven control valve is located to the front left of
the oven.
1. Remove the oven control panel as outlined
under PANELS AND COVERS.
2. Remove the three bracket screws attaching the
thermocouple valve mounting bracket to the
range.
F35425 (October 2005)
3. Remove the two screws attaching the bracket to
the thermocouple.
4. Open the oven door.
5. Remove capillary tube from all routing clips.
NOTE: When straightening the capillary tube be sure
not to place kinks in tubing.
Page 6 of 23