Table of Contents
Advertisement
9. Adding Paper and Toner
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease or the paper may
misfeed.
1.
Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
3.
Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in Trays 2-3 by adjusting the positions of side fences and
end fence. For details, see "Changing the Paper Size in Trays 2-3", Paper Specifications and
Adding Paper.
Loading Paper into the Bypass Tray
Use the bypass tray to use OHP transparencies, adhesive labels, translucent paper, and paper that
cannot be loaded in the paper trays.
124
DCH043
DCH044
Advertisement
Table of Contents
