Replacing A System Processor Module - IBM 9006-22P Servicing

Figure 89. Releasing the system processor module from the tool
Replacing a system processor module for the 9006-22P
To replace a system processor module in the system, complete the steps in this procedure.
Before you begin
Unless you are replacing both processors, ensure that the replacement processor has the same part
number as the processor you are removing.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Inspect the system processor socket area and remove any dust or debris (use a can of compressed
air).
3. Remove the replacement processor module from the shipping tray. Align the beveled corner (A) of
the tool over the beveled corner of the module as shown in Figure 90 on page 96. Ensure that the
guide (B) fits into the alignment pin (C).
Removing and replacing parts in the 9006-22P 95