Table of Contents
Advertisement
Figure 60. Releasing the system processor module from the tool
Replacing a system processor module in the 9006-12P system
Learn how to replace a system processor module in the IBM Power System LC921 (9006-12P) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Inspect the system processor socket area and remove any dust or debris (use a can of compressed
air).
3. Remove the replacement processor module from the shipping tray. Align the beveled corner (A) of
the tool over the beveled corner of the module as shown in Figure 61 on page 68. Ensure that the
guide (B) fits into the alignment pin (C).
Removing and replacing parts in the 9006-12P system 67
Advertisement
Table of Contents
