Fans; Removing A System Fan - IBM 9006-22P Servicing

Figure 30. Replacing the PCIe riser
a. Retract the retaining pin (B) so the arrow points to the system.
b. Insert the riser, using the slots and alignment pins to properly insert the riser. Push the riser firmly
into the system backplane.
c. Set the retaining pin (B) to secure the riser.
d. If the system has a thumbscrew near the front of the riser, tighten that thumbscrew.
8. Fully insert the rear drive trays.
For instructions, see "Replacing a rear disk drive in the 9006-22P system" on page 18.
What to do next
Prepare the system for operation. For instructions, see "Preparing the 5104-22C, 9006-22C, or 9006-22P
system for operation after you remove and replace internal parts" on page 118.
Removing and replacing fans in the 9006-22P
Learn how to remove and replace the fans in the system.
Removing a system fan from the 9006-22P
To remove the fans in the system, complete the steps in this procedure.
Before you begin
(L008)
34 Power Systems: Servicing the 9006-22P