Setup/Startup - Graco LineLazer V 200HS Standard Series Operation

Setup/Startup

Setup/Startup
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection, splash-
ing fluid and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before clean-
ing, checking, or servicing the equipment.
1. Perform Pressure Relief Procedure, page 11.
2. Perform Grounding Procedure (For Flammable
Materials Only), page 11, if using flammable mate-
rials.
3. Fill throat packing nut with Throat Seal Liquid (TSL)
to decrease packing wear.
4. Check engine oil level. Add SAE 10W-30 (summer)
or 5W-30 (winter). See engine manual.
5. Fill fuel tank.
ti27611a
12
6. Set pump switch to OFF.
7. If removed, install strainer.
8. Turn prime valve down. Turn pressure control coun-
terclockwise to lowest pressure.
ti28014a
NOTE: Minimum hose size allowable for proper
sprayer operation is 3/8 in. x 22 ft for LL200
9. Place siphon tube set in grounded metal pail par-
tially filled with flushing fluid. Attach ground wire to
true earth ground. Use water to flush water-base
paint and mineral spirits to flush oil-base paint and
storage oil.
ti27610a
ti27613a
ti23144a
ti27612a
3A3426A Operation
ti27504a
ti2 8 0 1 5 a
.
HS