Gun Cable Adjustment - Graco LineLazer V 200HS Standard Series Operation

Gun Placement

Gun Cable Adjustment

Adjusting the gun cable will increase or decrease the
gap between the trigger plate and the gun trigger. To
adjust trigger gap, perform the steps below.
HP Auto Series
(has 2 locations)
1. Use wrench to loosen locking nut on cable adjuster.
2. Loosen or tighten adjuster until desired result is
achieved. NOTE: More thread exposed means less
gap between gun trigger and trigger plate.
3. Use wrench to tighten locking nut on the adjuster.
Adding Gun Cable (HP Auto Series)
The HP Auto Series can be equipped with two gun actu-
ators. Each gun actuator is capable of operating one
cable.
1. Select cable end with adjuster.
2. Install exposed cable through cable bracket slot.
20
Standard Series
ti27884a
ti27885a
ti27804a
ti27805a
3. Insert plastic cable retainer into cable bracket hole.
ti27806a
4. Install cable end onto trigger plate pin and install
clip.
5. Route cable around unit and up through cable holes
behind hose mount.
6. Route cable end loop through rectangular hole in
bracket and insert plastic cable retainer into the
actuator bracket. Install cable end onto actuator rod
and install pin.
ti27807a
ti27808a
ti27809a
3A3426A Operation