Table of Contents
Advertisement
H. Fixed Glass Assembly Removal and Re-
placement
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches away from the tabs
on the glass frame. Remove glass assembly from the
appliance. See Figure 11.5.
Replacing Fixed Glass Assembly
• Replace the glass assembly on the appliance. Hold glass
in place with one hand. Use the other hand to pull out
and latch the four glass assembly latches onto the glass
frame tabs.
• Inspect and operate all glass latches to ensure they
move freely and no obstructions are present.
• Reinstall decorative barrier front.
GLASS FRAME
TABS
Figure 11.5 Fixed Glass Assembly
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Heat & Glo • 6KX-AU Installation Manual • 2589-980 Rev. B • 5/23
I. Install Decorative Barrier Front
WARNING! Risk of Fire! Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts could cause fireplace to
overheat.
IMPORTANT! This fireplace requires an installed
decorative barrier front to prevent direct contact with
the hot viewing glass. DO NOT operate the fireplace
with the barrier removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative barrier front.
77
Advertisement
Table of Contents
