Install The Log Assembly - Heat & Glo 6KX-AU Installation Manual

G. Install the Log Assembly
CAUTION: Logs are fragile, handle with care.
NOTICE: To simplify the installation process, positively
identify each individual log before beginning installation.
See Figure 1. Key log location features are shown in
Figure 2.
2 2
1 1
Figure 1. Log Identification - LOGS-6KX
Log #1: Position Log #1 along the log positioning ledge referenced in Figure 2. Slide Log #1 back until it contacts the log stop.
Log #2: Position the right end of Log #2 against the log pin as shown in Figure 4. Refer to Figure 2 for log pin location.
Position the bottom side of the log on the log shelf and place it just behind the log shelf return bend. The back side of the
log will touch the back refractory, if installed. Set the left end of the log on the flat area of Log #1 shown in Figure 3.
FLAT AREA FOR LOG 5 FLAT AREA FOR LOG 5
1 1
Figure 3 Place Log #1
74
3 3 4 4 5 5
6 6
FLAT AREA FOR LOG 2 FLAT AREA FOR LOG 2
LOG STOP LOG STOP
Heat & Glo • 6KX-AU Installation Manual • 2589-980 Rev. B • 5/23
Log Assembly: LOGS-6KX
LOG 1 POSITIONING LEDGE LOG 1 POSITIONING LEDGE
LOG STOP LOG STOP
Figure 2 Log Location Features
ALIGN LOG #3 WITH EDGE OF BURNED OUT AREA ALIGN LOG #3 WITH EDGE OF BURNED OUT AREA
FLAT AREA FOR LOG 3 FLAT AREA FOR LOG 3
2 2
LOG SHELF RETURN BEND LOG SHELF RETURN BEND
1 1
Figure 4 Place Log #2
LOG PIN LOG PIN
LOG PIN LOG PIN