Table of Contents
Advertisement
11 11
Appliance Setup
A. Remove the Shipping Materials
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
Remove shipping materials from inside or underneath the
firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative barrier front of the ap-
pliance, depending on the fireplace model. Splatter
guards must be removed before appliance is fired.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
C. Install the Black Glass Refractory
SIDE REFRACTORY BRACKET
(Assembly breaks into two pieces)
Figure 1 Side Refractory Bracket
68
Heat & Glo • 6KX-AU Installation Manual • 2589-980 Rev. B • 5/23
KIT COMPONENTS
(1) Glass Refractory Assembly (Back, Left, Right)
(1) Side Refractory Bracket Assembly (See Figure 1)
(1) Back Insulation Board
(2) Side Insulation Board
(1) Back Refractory Support (See Figure 2)
(1) Base Refractory
(1) Top Refractory Panel
REQUIRED TOOLS
• Screw gun equipped with 1/4 in (6 mm) socket
• 1/4 in. (6 mm) wrench
Installation Instructions
1. Remove decorative front, appliance glass assembly
and logs, if installed.
2. Locate back refractory support, included in manual
bag assembly shipped with the kit. Remove LED cov-
ers from refractory support by bending as shown in
Figure 2.
Discard LED covers.
3. Bend two tabs on back refractory support as shown in
Figure 2. Bend at perforation and remove.
BEND ALL TABS 90 DEGREES
36 INCH MODELS: 7
BEND AT PERFORATION AND REMOVE
Figure 2 Back Refractory Support
36 INCH MODELS:
Advertisement
Table of Contents
