Rotor As Individual Component; Ordering Notes; Ordering Examples - Siemens SIMOTICS T-1FW6 Configuration Manual

3.4.1.3

Rotor as individual component

3.4.1.4

Ordering notes

You can order a complete built-in torque motor (stator, rotor with transport locks) using a single
order designation (article number). Spare parts and accessories can be ordered by specifying
separate order designations (on this topic, see Chapter "Ordering examples (Page 47))".
Note
The cables are permanently attached. You cannot subsequently change the cables.
When selecting a motor, also observe the information in Chapter "Data of the cable on the stator
(Page 458)".
The cooling connection adapter is not included in the standard built-in torque motor. The
separate order designation for the cooling connection adapter is provided in Chapter "Options
(Page 90)".
If, for design reasons, only individual components can be installed (stator and rotor
separately), the stator and rotor can be separately ordered and shipped.
3.4.1.5

Ordering examples

Example 1:
Stator and rotor premounted with transport locks; cooling jacket, axial cable outlet, for
SINAMICS S120 drive system, Motor Module with 18 A rated current,1 x PTC triplet 130 °C +
1 x Pt1000 as temperature sensors:
1FW6 Built-in torque motors
Configuration Manual, 09/2022, A5E52220645B AA
Description of the motor
3.4 Selection and ordering data
47