Rotor As Individual Component; Ordering Notes - Siemens SIMOTICS T-1FW6 Series Configuration Manual

2.5.1.3

Rotor as individual component

Note
IATA regulations must be complied with when transporting rotors by air.
2.5.1.4

Ordering notes

You can order a complete built-in torque motor (stator, rotor with transport locks) using one
single order designation (Article number). Spare parts and accessories can be ordered by
specifying separate order designations (see "Ordering examples (Page 42))".
Note
The cables are permanently attached. You cannot subsequently change the cables.
When selecting a motor, also observe the information in Chapter "Data for the power cable
at the stator (Page 164)".
If, for design reasons, only individual components can be installed (stator and rotor
separately), then the stator and rotor can be separately ordered and shipped.
Naturally cooled 1FW6 built-in torque motors
Configuration Manual, 07/2017, 6SN1197-0AE01-0BP3
Description of the motor
2.5 Selection and ordering data
41