Rotor As Individual Component; Ordering Notes - Siemens SIMOTICS T-1FW6 Configuration Manual

Built-in torque motors for sinamics s120

Hide thumbs Also See for SIMOTICS T-1FW6:

Table of Contents

Rotor as individual component

IATA regulations must be complied with when transporting rotors by air.

You can order a complete built-in torque motor (stator, rotor with transport locks) using a

single order designation (article number). Spare parts and accessories can be ordered by

specifying separate order designations (see "Ordering examples (Page 44))".

The cables are permanently attached. You cannot subsequently change the cables.

When selecting a motor, also observe the information in Chapter "Data for the power cable

at the stator (Page 506)".

The cooling connection adapter is not included in the standard built-in torque motor. For the

separate order designation, see Chapter "Options (Page 91)".

If, for design reasons, only individual components can be installed (stator and rotor

separately), the stator and rotor can be separately ordered and shipped.

1FW6 Built-in torque motors

Configuration Manual, 07/2017, 6SN1197-0AE00-0BP9

Description of the motor

2.5 Selection and ordering data