Panasonic AG-EZ1UP Operating Instructions Manual page 76

ENGLISH
Before Requesting Service
Power Source
| Symptom cause Teton Pa
Movie Camera does not turn i Battery Pack is not attached. eAttach it correctly.
on.
e®AC Adaptor is not connected. Connect AC Adaptor correctly to Movie
Camera.
®Battery Pack is exhausted. Use a fully charged one. | at |
H Recording was paused for more than ®Set [POWER] Switch to "OFF" to turn off
5 minutes. Movie Camera, and then set it to "ON" again.
prroueniowmemeor [www —SOSC~*~z
poPover Soe Fuon esbecone aca | vision Ganaaiomonnonton | a
Tab of inserted video cassette is set to *Set it to "REC".
"SAVE".
®No video cassette is inserted. *Insert a video cassette with the tab set to Se
"REC",
@Tape has reached its end. elnsert a new video cassette. 16 |
eDate and time cannot be ®Date and time have not been set. eSet date and time.
recorded.
eDate and time are not [DATE/TIME] Button was not pressed. Press [DATE/TIME] Button.
displayed in the Viewfinder.
*Button-type battery is exhausted. *Replace it with a new CR2032 battery.
®Movie Camera turns off soon.
Recording
@No picture appears in the
Viewfinder.
®|ndications in the Viewfinder
are not clearly visible.
Recording cannot be started.
Playback
@No playback picture is > ® [POWER] Switch is set to "OFF". Set it to "ON" and press [VCR/CAMERA}
reproduced. Button so that "VCR" Indication Lamp lights.
Movie Camera is not connected to TV set or Connect Movie Camera to TV set correctly.
I it is connected incorrectly.
Wrong channel is selected on TV set. @Select correct channel.
®Picture is notin color. ®Color adjustment on TV set is not made e Adjust color control on TV set.
property.
@Mosaic-like patterns appear Cue or Review Playback is being performed. ®This is nota malfunction.
in the picture. .
Date and time are not [DATE/TIME] Button was not pressed. Press [DATE/T|ME] Button.
displayed in the playback
picture.
Others
®lnfrared Remote does not ®Button-type battery in the Remote is *Replace it with a new CR2025 battery.
work. exhausted.
Selected Remote mode is not correct. *Set it correctly.
(76)