Grizzly T33901 Owner's Manual page 22

Place rack inside of table support bracket,
4.
mesh it with pinion, and slide bracket over
column, as shown in Figure 17.
Table Support Bracket
Figure 17. Example of sliding table support
bracket and rack over column.
Slide column collar over column with beveled
5.
edge facing down, as shown in Figure 18,
then fit beveled edge of collar over rack and
tighten set screw to secure.
Figure 18. Correct column collar orientation.
Note: Do not overtighten screw or you may
split collar. Also make sure rack is seated
firmly between collar and column base.
-20-
6.
7.
Beveled
Edge
Figure 20. Example of aligning headstock with
8.
With lifting help, carefully lift headstock and
slide it onto column (see Figure 19).
Figure 19. Headstock placed on column and
location of headstock set screws.
Use measuring tape or ruler to find and mark
center of base, then suspend plumb bob from
center of headstock spindle over base, as
shown in Figure 20.
center of base.
Adjust headstock on column until it is directly
over center of base, as indicated by plumb
bob, then secure headstock by tightening (2)
set screws shown in Figure 19.
Model T33901/T33902 (Mfd. Since 07/23)
Plumb
Bob