Function Block Navigation Menus - Omron SYSMAC CS Series Operation Manual

Overview of User Interface

2-2-2 Function Block Navigation Menus

Menus in Normal Display Mode
Main Menus
Menu Submenu/
Command
File
New
Open
Close
Save
Save As
Add IST File
Sort
Print
Recent File
Activate Serial Port
Driver
Find LCU/LCB
62
Creates a function block navigation area and project.
Opens a multi-node file in the current multi-node folder. All
related files are opened automatically.
Closes the current function block navigation area.
Saves the current function block navigation area and
overwrites the previous one in the multi-node folder.
Saves the current function block navigation area in a
different multi-node folder.
Imports a function block file (.ist) created in version 1.00
into the current function block navigation area.
Note If the active function block file has been changed, it
must be saved before executing the above.
Manual Sorts function block files in order of node numbers.
Auto If checking is enabled, function block files are read in
order of node numbers when Add IST File or Open is
selected.
Function Prints a list of registered function blocks and a list of all
Block ITEMs.
Block Prints block diagrams.
Diagram
Cross- Prints cross-references.
Refer-
ence
Se- Prints sequence tables.
quence
Control
All Prints all of the above.
Monitor Prints the monitor tag list.
Tag List
CSV Tag Prints a list of CSV tags.
List
Monitor Prints a list of CX- Process Monitor Plus tags.
Plus Tag
List
User Link Prints user link tables.
table
Connec- Prints a connection map.
tion Map
Displays up to the four files most recently used.
Connects to the PLC via Host Link.
Displays the serial (Host Link), Controller Link, or Ethernet
Link networks of the PLC to which the CX-Process Tool is
connected and searches for Loop Controllers. It gets the
network addresses, node addresses, and unit address of
all Loop Controllers found and sets them in the currently
active node function block file.
Description
Section 2-2
Conditions for
selection
---
---
When an LCU or
LCB element is
selected