Installation - Omron SYSMAC CS Series Operation Manual

Installation

2-1

Installation

1, 2, 3...
Selecting Communications Drivers
46
To use the CX-Process Tool, the following software must be installed on the
same computer. Either of these can be installed first.
1. CX-Process Tool
2. FinsGateway Embedded Version 3 or higher or CX-Server
The CX-Process Tool supports the following communications drivers.
• FinsGateway Ver. 3.12
• FinsGateway Ver. 2003
• CX-Server Ver. 2.2
Select the communications driver for installation according to the OS, commu-
nications, and applications to be used. The following tables are provided as a
selection guide.
Yes: Supported
No: Not supported
• OS
Communica-
tions driver i d i
Windows95SE/
FinsGateway Yes
Ver.3.12
FinsGateway No
Ver.2003
CX-Server Yes
Ver.2.2
Note 1. CX-Process Tool is supported for Windows NT (Service Pack 4 or later).
2. CX-Process Tool is supported for Windows 2000 Professional (Service
Pack 2 or later) only.
3. CX-Process Tool is supported for Windows XP Professional only.
• Communications
Communica-
ti tions driver d i
FinsGateway No
Ver.3.12
FinsGateway Yes
Ver.2003
CX-Server Yes
Ver.2.2
• Compatible Applications
Communica-
tions driver i d i
FinsGateway Yes
Ver.3.12
FinsGateway NO
Ver.2003
CX-Server No
Ver.2.2
The CX-Process Tool Setup Disk contains each of the communications drivers.
The following .exe files are required for setup.
WindowsNT
Windows98
(See note 1.)
Yes
No
Yes
Communications method
Toolbus Duplex Ethernet at
personal computer
No
Yes
No
Application
CX-Process CX-Process
Monitor Monitor Plus
Yes
Yes
No
Section
OS
WIndows2000 WindowsXP
(See note 2.) (See note 3.)
Yes Yes
Yes Yes
Yes Yes
Simultaneous online
(serial) connection
with CX-Programmer
No
No
Yes
SYSMAC OPC
Server
Yes
Yes
No
2-1