Cx-Process Tool Specifications - Omron SYSMAC CS Series Operation Manual

CX-Process Tool Specifications

1-3

CX-Process Tool Specifications

CX-Process Tool Specifications
Item
Product name
Model
Applicable PLCs
Applicable Units/Boards
,
, Computer
A li bl
Applicable
CPU
computer
OS
Memory
Hard disk space
Monitor
CD-ROM drive
Mouse
Software that must be installed
with the CX-Process Tool
CX-Process Tool
WS02-LCTC1-EV4
CS-series PLCs
Loop Control Units, Loop Control Boards, Process-control CPU Units, Loop-control
CPU Units
IBM PC/AT or compatible
Min. required: Pentium 133 MHz or faster, Recommended: Celeron 400 MHz or
faster
Microsoft Windows NT 4.0 (with Service Pack 4 or higher), Windows 95 (note *1),
Windows 98, Windows ME (note *2), Windows 2000 Professional, or Windows XP
Professional
*1 The CX-Process Tool cannot be used with Windows 95 when the computer is
connected through a Controller Link Support Board (PCI slot).
*2 When Windows ME is being used, the minimum processor speed is a 150 MHz
pentium.
Note When creating tag data for the CX-Process Monitor, install the CX-Process Mon-
itor on the same computer.
Min. required: 32 Mbytes, Recommended: 32 Mbytes or more
Min. required: 20 Mbytes of free space, Recommended: 30 Mbytes or more of free
space
Min. required: XGA, 256 colors; Recommended: SXGA, 65,536 colors min.
At least one
Recommended: Microsoft mouse or compatible pointing device
FinsGateway (note *1) or CX-Server
*1 When FinsGateway is installed, select any one of the following FinsGateway
Version 3 drivers or higher. (Select the appropriate one depending on the method
being used to communicate with the PLC.)
• Serial Unit Driver (for Host Link)
• CLK (PCI) Driver (See note.)
• Controller Link Driver (for Controller Link)
• ETN_UNIT Driver (for Ethernet)
The three drivers other than the CLK (PCI) Driver are also available in the
FinsGateway Version 2 (embedded).
Specification
Section 1-3
13