Status Light Troubleshooting Codes - Visioneer Patriot 470 User Manual

S L T
TATUS IGHT ROUBLESHOOTING
The status light indicates the current state of the scanner. A green status
light indicates the normal state of the scanner. A red status light
indicates that there is a hardware issue. Descriptions of the most
common patterns are listed below.
N O
ORMAL PERATION
Blinking green: indicates the scanner is waking up from power
■
saving and preparing to scan.
Steady green: indicates the scanner is ready to scan.
■
E C
RROR ODES
If your scanner experiences hardware problems, the status light will
blink red, and the LED flashes an "E" and the error code number.
The LED blinks back and forth
between "E" and the error code
number (such as 6).
The red light flashes the number
of times as the error code (6 in
this example).
The E-code number indicates what the hardware issue is. Use the table
listed on the next page as a reference for resolving hardware issues.
In all cases you should turn off your scanner and check your scanner
setup. Open the scanner and make sure your input tray is fully seated in
the scanner casing, make sure your ADF pad is securely snapped in
place, verify the connections to the PC and to the wall.
T
ROUBLESHOOTING
C
ODES
125