Status Light Troubleshooting Codes - Visioneer PATRIOT 680 SCANNER User Manual

92 V P
ISIONEER ATRIOT
680 S U ' G
CANNER SER S UIDE
Make sure to align the paper guides to the edges of the paper. If you are
scanning small items that are smaller than the paper guides' minimum
adjustment, scan these items on the flatbed glass instead.
S L T
TATUS IGHT ROUBLESHOOTING
A green status light indicates the normal state of the scanner.
Normal Operation
Blinking green: indicates
■
and preparing to scan.
Steady green: indicates
■
Error Codes
If your scanner experiences hardware problems, the status light will blink red,
and the LED flashes an "E" and the error code number.
The LED blinks back and forth
between "E" and the error code
number (such as 4).
The E-code number indicates what the hardware issue is. Use the table listed
on the next page as a reference for resolving the hardware issue.
In all cases, you should turn off your scanner and check your scanner hardware
setup.
■ Open the ADF and make sure the ADF pad is securely snapped into place,
make sure the main roller is securely seated in its housing, make sure the
input tray is fully seated into the ADF and close the ADF cover.
■ Make sure the ADF cable is fully and securely seated into the ADF port on
the bottom of the scanner. The ADF will not function properly without the
cable being plugged in securely.
■ Verify that the scanner is unlocked. If the scanner is locked, turn off the
scanner and unlock it, then turn the scanner back on.
C
ODES
the scanner is waking up from power saving
the scanner is ready to scan.
The red light flashes the number
of times as the error code.