Thread Cutter Switch - ELNA eXcellence 782 Instruction Book

(1)
(6)
3.
4.
(3)
(4)
(1)
(2)

Thread Cutter Switch

If you wish to use the thread cutter switch, insert the
1.
pin connector into the thread cutter switch jack on the
machine.
5.
1. First make sure the power switch is off.
2. Remove the cable tie from the cable.
(5) 3. Insert the machine plug of the power supply cable
4. Insert the pin connector into the thread cutter switch
(8)
5.
5. Insert the power supply plug into the wall outlet, and
(7)
2.
(2)
After sewing, depress the thread cutter switch on the
right side of the foot control to trim both the needle and
bobbin threads.
Do not depress the thread cutter switch until the start/
stop button turns blue (2).
(3)
14
into the machine socket.
jack on the machine.
turn the power switch on.
(1) Power switch
(2) Cable tie
(3) Pin connector
(4) Thread cutter switch jack
(5) Machine plug
(6) Machine socket
(7) Power supply plug
(8) Wall outlet
(1) Thread cutter switch
NOTE:
• The thread cutter switch does not work without the
foot control being depressed first.
• Bundle the cables with the cable tie as necessary.
(3) Cable tie