ELNA eXcellence 782 Instruction Book page 23

1.
(2)
(1)
(1)
(3)
(2)
3.
(4)
(6)
(7)
(5)
5. 6.
(9)
(8)
7. 8.
2.
(2)
(1)
4.
(10)
Winding the bobbin
NOTE:
Set the speed control slider at the fastest position (refer
to page 15).
1. Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot.
Draw the thread to the left and forward around the
thread guide.
Draw the thread to the rear and to the right around
and under the guide plate.
(1) Guide slot
(2) Thread guide
(3) Guide plate
2. Firmly pull the thread to the right while holding it with
both hands.
Bobbin winding when the extra spool pin is attached
If you want to wind the bobbin with the extra spool pin,
do not pass the thread into the guide slot. Instead,
draw the thread around the thread guide as shown.
(1) Guide slot
(2) Thread guide
3. Put the bobbin on the bobbin winder spindle.
Be sure that the bobbin snaps into the place.
(4) Bobbin
(5) Bobbin winder spindle
(6) Slit
(7) Spring (Projection)
4. Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
5. Insert the thread into one of the slits of the flange
plate and pull the thread to cut.
(8) Flange plate
(9) Slit
6. Push the bobbin to the right. The visual touch screen
will show the bobbin winding sign.
NOTE:
Do not move the bobbin winder spindle while the
machine is running.
7. Start the machine.
Stop the machine when the bobbin is fully wound and
stops spinning.
Return the bobbin winder spindle to its original
position.
8. Remove the bobbin. Cut the thread with the bobbin
thread cutter B.
(10) Bobbin thread cutter B
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
21