ELNA eXcellence 782 Instruction Book page 130

6.
(7)
(8)
(−) (+)
(9)
6. Sew the fabric while guiding it with your hands.
The status indicator will turn red during operation.
The buzzer sounds and the stitch length will be
longer than the setting when the fabric moves too
fast.
(7) Status indicator
* The A.S.R. foot holder also can be used with ruler work
or variable zigzag (refer to the next page).
7. Be sure to pull out the A.S.R. plug from the
attachment connector on the back of the machine to
remove the A.S.R. foot holder.
NOTE:
• Set the speed control slider at the fastest position
(refer to page 15).
• Sewing results may vary depending upon sewing
conditions. Always make a test stitch on an extra
piece of fabric to check sewing results. Move the
speed control slider to set the sewing speed to
middle if the stitch length become too short when
the fabric guiding with your hands.
• The machine sews at low speed when you are not
guiding fabric.
• Accurate Stitch Regulator sensor cannot detect
fabric movement in the area 2 cm (3/4˝) from the
rear side edge of the fabric (the sensor only can
detect the fabric movement under the sensor.
• The machine sews at low speed in the area 2 cm
(3/4˝) from the edge of the fabric.
• Regularly check if the inside of the sensor on the
underside of the A.S.R. foot holder is not dirty.
• Regularly clean the black window on the underside
of the A.S.R. foot holder with a soft cloth.
(8) Sensor
Adjusting stitch length
The stitch length varies depending on (the color or
thickness of) the fabric or the presser height.
Press the adjust key to adjust stitch length.
Press the "+" key to increase the stitch length.
Press the "–" key to decrease the stitch length.
(9) Stitch length adjustment key
NOTE:
The adjustable stitch length range is 1.00 mm to
4.00 mm.
128