Table of Contents
Advertisement
4.
A B
(3)
2.
1.
3.
5.
6.
7.
8.
(1)
Insert the extra spool pin into the hole under the top
cover.
Place a spool of thread on the extra spool pin and the
spool stand (refer to page 20).
(3) Extra spool pin
Draw both threads from the spools and pass them
through the threading points from 1. to 4.
Slip the thread A* through the lower thread guide 5., then
pass through points 6. and 7. as illustrated.
Thread the thread B* through the front hole of lower
thread guide 5., then pass it through the needle hole 8.
Make sure that the two strands of thread from the spools
do not get tangled.
* A: Thread from spool pin, B: Thread from extra spool
pin.
NOTE:
• Threading from points 1. to 4. is the same as for a
single needle (refer to pages 23-24).
• The needle threader cannot be used with the twin
needle.
After twin needle sewing is finished, press the twin
needle key and the warning message will appear.
(1) Twin needle key
Replace the twin needle with a single needle and press
the OK key.
83
Advertisement
Table of Contents
