Changing The Foot Attachment - ELNA eXcellence 782 Instruction Book

(2)
(1)
1.
(5)
(8)
2.
(9)
(8)
(9)
3.
(10)
(10)
(3)
(4)
(6)
(7)
129

Changing the Foot Attachment

This foot holder comes with the A.S.R. closed-toe foot
ASR-QC attached. However, it is also compatible with
the A.S.R. open-toe foot ASR-QO, the A.S.R. clear view
foot ASR-QV, and the A.S.R. ruler work foot ASR-QR.
(1) A.S.R. closed-toe foot ASR-QC
(2) A.S.R. open-toe foot ASR-QO
(3) A.S.R. clear view foot ASR-QV
(4) A.S.R. ruler work foot ASR-QR
Refer to pages 130 and 131 for ruler work or variable
zigzag settings.
CAUTION:
Always make sure to press the lockout key before
replacing the presser foot.
1. Press the needle up/down button to raise the needle.
Press the lockout key.
Press the presser foot lifter button to raise the
presser foot.
(5) Needle up/down button
(6) Lockout key
(7) Presser foot lifter button
2. To remove the foot, pull the A.S.R. foot in the
direction of arrows while pushing the button on the
backside of the A.S.R. foot holder.
(8) A.S.R. foot holder
(9) Button
3. To attach the foot, set both ends to the A.S.R. foot
holder and push the foot up to fit in place.
(10) Both ends