Table of Contents
Advertisement
CO LINE ATTRIBUTES PROGIUMMING
Infinite 816 Key Telephone System
CO Lfne Attributes Programming (Cont'd)
720.2
CO LINE CONFIGURATION
gmmming
Steps
Description
If the system
is in the Programming
mode,
continue
using
program
codes.
If starting
to
program
here,
enter
the Programming
mode
first (See Paragraph
700.4).
If any CO line features
are to be changed:
a. Dial an asterisk
[*] and [ 121 on the d&l pad.
b. Press the CO line button
of the line
to
be
programmed.
c. Toggle the program
buttons
on or off so the
LEDs light up or extinguish.
Line Type (CO/'PBXl
- Each outside
line can
be programmed
to be either a CO line (LED on)
or a PBX line. When
marked
PBX, a one- or
two-digit
dial code may be entered,
after which
toll restriction
is applied.
(Data Field 30).
Default:
By default,
all are lines are CO lines.
Signaling
(DTBW/Pulse)
- Each line can also
be programmed
as either
DTMF
(tone) or dfal
pulse.
When
a line is assigned
as dial pulse,
the break/make
ratio
and dial speed can be
programmed.
d. Press HOLD
to enter
data.
The next CO
line will light for programming.
Default:
By default,
all are set for IYTMF ILED
on).
Toll Override
-
A
line may be marked
for Toll
Override which
allows toll restricted
stations
to
dial on this line.
Default:
By default,
no lines are marked
for
Toll Override
(LED off).
Private
Line - This feature
allows a CO line to
be marked
private
and to flash and ring at the
specffled
station
only. This line cannot
be re-
trieved from System Hold by other stations
and
does not have Night Service. This line can be
programmed
to Preset CalI Forward.
Ifthe
LED
is unlit, the Une is NOT a private line. If a line
is programmed
as private,
go to Data Field 04
and remove
access
to that
line from
alI other
stations.
Ah
go to Data Field
13 and remove
ringing
of that line from any other
station.
720-2
Preliminary Issue, November 1991
Advertisement
Table of Contents
