Table 6-1, Configuration Module Kit - 011-00979-00; Table 6-2, Configuration Module Kit - 011-00979-03 - Garmin G1000 NXi Supplemental Maintenance Manual

Table 6-1, Configuration Module Kit – 011-00979-00
Item
Configuration Module PCB Board Assembly w/EEPROM & Temp
1
Sensor
2 Spacer, Config Module
3 Cable, 4-Conductor Harness
4 Pins, #22 AWG (HD)
Removal:
1. Disconnect connector from LRU.
2. Remove 2 screws (8) from cover (7) and remove cover.
3. Unplug connector from configuration module (1).
4. Remove configuration module.
Installation:
1. Inspect connector for damaged pins (4).
2. Place configuration module (1) in position.
3. Insert connector into configuration module (1).
4. Assembly of the connector is the reverse of disassembly.
5. Checkout per Section 6.4.3.
GTX 3X5R Configuration Module Removal & Replacement
GTX 3X5 series transponders require the installation of a configuration module. The
configuration module is installed in the connector assembly, as shown in Figure 6-2.
Table 6-2, Configuration Module Kit – 011-00979-03
Item
1 Configuration Module PCB Board Assembly w/EEPROM
2 Cable, 4-Conductor Harness
3 Pins, #22 AWG (HD)
G1000 NXi Supplemental Maintenance Manual
Textron Aviation G36/G58
Description
Description
Page 6-5
Garmin Part
Qty Needed
Number
1
012-00605-00 or -02
1 213-00043-00
1 325-00122-00
5 336-00021-00
Garmin Part
Qty Needed
Number
1 011-02178-00
1 325-00122-00
4 336-00021-00
190-02765-05
Revision 2