Garmin G1000 NXi Supplemental Maintenance Manual page 40

GTX 33 ES Software/Configuration Loading (if installed)
Follow this procedure to configure the system to use a GTX 33 ES Transponder. Do not follow
the procedures in this section if the aircraft is not equipped with a GTX 33 ES.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "Baseline
Option – Legacy – GTX 33ES Installation" and press the ENT key to select it.
Press the CHK All softkey.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
GDL 69 Software/Configuration Loading (if installed)
Follow this procedure to configure the GDL 69 Receiver. Do not follow the procedures in this
section if a GDL69 unit is not installed.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "Baseline
Option – Legacy – GDL 69 Installation" and press the ENT key to select it.
Press the CHK All softkey.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
G1000 NXi Supplemental Maintenance Manual
Textron Aviation G36/G58
Page 3-24
190-02765-05
Revision 2