6.3
GDL 69A SXM (if installed)
Removal:
Remove the PFD (reference Section 6.1)
1.
Unlock the GDL 69A handle by loosening the Phillips screw on the handle.
2.
Pull the handle upward to unlock the GDL 69A. Gently remove the unit from the rack.
3.
Reinstallation:
1.
Visually inspect the connectors to ensure there are no bent or damaged pins. Repair
any damage.
2.
Lift the handle and gently insert the GDL 69A into its rack. The handle should engage
the dogleg track.
3.
Press down on the GDL 69A handle to lock the unit into the rack.
4.
Lock the handle to the GDL 69A body using the Philips screw. Torque the handle screw
to 10-14 in-lbs.
Configure and test the GDL 69A according to Section 7.3.
5.
6.4
Configuration Modules
Configuration Module Removal & Replacement
Configuration modules (Reference Figure 6-1 and
G1000 NXi Supplemental Maintenance Manual
Textron Aviation G36/G58
Page 6-3
190-02765-05
Revision 2