Table 6-4. Configuration Module Kit 011-00979-00 (P1001)
Figure 6-5
Description
Reference
1
Configuration Module, PCB Board Assembly w/EEPROM
2
Spacer, Configuration Module
3
4-Conductor Harness
4
Pin Contact, Crimp, #22D
Figure 6-5. Backshell Assembly (Configuration Module with Spacer)
Removal
1. Disconnect the connector from the GTN.
2. Remove two screws (5) from cover (6) and remove cover.
3. Unplug the connector from the configuration module (1).
4. Remove the configuration module from the backshell connector.
Reinstallation
1. Inspect the connector for damaged pins (4).
2. Apply spacer (2) by wrapping it around the PCB board (1) making sure to insert the plastic
connector mounted on the board into the hole provided in the spacer.
3. Place the configuration module (1) in position.
4. Insert connector into the configuration module (1).
5. Place the cover (6) back on the connector and reinstall screws (5).
System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Page 6-12
Garmin P/N
012-00605-00
213-00043-00
325-00122-00
336-00021-00
190-01007-A1
Rev. 5