Configuration Module (P1001 Only); Figure 5-5 Backshell Assembly; Table 5-2 Configuration Module Wire Color Reference Chart; Table 5-3 Configuration Module Kit P/N 011-00979-03 (P1001) - Garmin GTN 6 Series Maintenance Manual

5.7 Configuration Module (P1001 Only)

GTN P1001 connector assemblies serve as the housing for a configuration module. This section lists
configuration module assembly for existing GTN installations.

Table 5-2 Configuration Module Wire Color Reference Chart

Red
Black
Yellow
White
NOTE
The pin contacts supplied with the GTN configuration module are specifically made to
accommodate 28 AWG wire. The crimp tool should have the indenter set to the correct
setting when crimping these contacts to the configuration module harness.
Configuration modules are located within the GTN harness connector backshell. Refer to Figure 5-5. The
configuration module kit listed in Table 5-3 is recommended for all replacements.

Table 5-3 Configuration Module Kit P/N 011-00979-03 (P1001)

Refer to
Figure 5-5
1 Configuration module, PCB board assembly w/EEPROM
3 4-conductor harness
4 Pin contact, crimp, #22D
Removal
1. Disconnect the connector from the GTN
backplate assembly.
2. Remove two screws (8) from cover (7) and
remove cover. Refer to Figure 5-5 for this step.
3. Unplug the connector from the configuration
module (1).
4. Remove the configuration module from the
backshell connector.
Replacement
1. Inspect the connector for damaged pins (4).
2. Place the configuration module (1) in position.
3. Insert connector into the configuration module
(1).
4. Place the cover (7) back on the connector and
reinstall screws (8). Refer to Figure 5-5 for this
step.
190-01007-B1
Rev. 4
Color Function
Vcc
Ground
Data
Clock
Description
GTN 6XX/7XX Part 27 AML STC Maintenance Manual
P1001 Contact
65
64
62
63

Figure 5-5 Backshell Assembly

(Potted Configuration Module)
Garmin P/N
011-02178-00
325-00122-00
336-00021-00
Page 5-13