KTM Freeride E-XC 2019 Owner's Manual page 86

Hide thumbs Also See for Freeride E-XC 2019:
Table of Contents

Advertisement

14 BRAKE SYSTEM
84
Main work
Move the brake fluid reservoir attached to the right of the han-
dlebar to a horizontal position.
Remove screws
Take off cover
A00200-11
Remove screws
Remove the cable tie.
Press back the brake linings by slightly tilting the brake caliper
laterally on the brake disc.
Carefully pull the brake caliper backward from the brake disc.
Press the brake piston back to its basic position and make sure
that no brake fluid overflows from the brake fluid reservoir,
extracting brake fluid if necessary.
A00130-10
Remove cotter pin
6
Remove pin
Take off retainer spring
Clean the brake caliper.
Position new brake linings.
Info
Always change the brake linings in pairs.
A00131-10
Position retaining spring
6
Mount pin
Info
To make it easier to mount the pin, push the retainer
spring down.
Make sure the retaining spring is seated correctly.
Mount cotter pins
Position the brake caliper. Mount screws
but do not tighten yet.
Operate the front brake lever several times until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the front brake lever in the activated position.
The brake caliper straightens.
Tighten screws
Guideline
A00130-10
Screw, front
brake caliper
Remove the means of securing the front brake lever.
Mount the cable tie.
1
.
2
3
with membrane
.
4
with spacers.
5
.
.
7
and remove the brake linings.
7
.
.
5
.
4
4
.
M8
25 Nm (18.4 lbf ft)
with the spacers
Loctite
243™
®

Advertisement

Table of Contents
loading

Table of Contents