Table of Contents
Advertisement
Configuring SMB
This machine uses the Server Message Block (SMB) communication protocol to save scanned data to a shared folder,
for example. Depending on the network environment, you may have to set the computer name and workgroup name
of the machine, and configure the SMB client information when connecting to an SMB server.
Setting the Computer Name and Workgroup Name(P. 84)
Configuring an SMB Client(P. 84)
Setting the Computer Name and Workgroup Name
Set the computer name used to identify the machine in a network and the workgroup name to identify the group that
the machine belongs to.
Configure these settings using Remote UI from a computer. You cannot use the control panel to configure the
settings.
Administrator privileges are required. The machine must be restarted to apply the settings.
1
Log in to Remote UI in System Manager Mode.
2
On the Portal page of Remote UI, click [Settings/Registration].
Remote UI(P. 395)
3
Click [Network Settings]
➠
The [Edit Computer Name/Workgroup Name Settings] screen is displayed.
4
Enter the computer name and workgroup name of the machine, and click [OK].
Enter using single-byte alphanumeric characters.
In an Environment with WINS
●
Select the [Use NetBIOS] checkbox.
●
You cannot register names that start with an asterisk (*) to the WINS server.
5
Restart the machine.
➠
The settings are applied.
Configuring an SMB Client
Configure the settings when connecting to an SMB server (such as the computer with the shared folder) and the
version of SMB to use with the SMB client.
* This setting is available only for MF267dw II.
Configure these settings using Remote UI from a computer. You cannot use the control panel to configure the
settings.
Administrator privileges are required.
Setting Up
[Computer Name/Workgroup Name Settings]
Restarting the Machine(P. 109)
84
Starting Remote UI(P. 393)
Portal Page of
8WFY-01X
[Edit].
Advertisement
Table of Contents
