Engine Oil And Oil Filter Change - Triumph Tiger 850 Sport 2020 Owner's Handbook Manual

Maintenance
Running the engine with insufficient
engine oil will cause engine damage.
If the low oil pressure indicator
remains on,
immediately and
situation.
1
4
3
1. Filler
2. Sight glass
3. Engine oil level (correct level shown)
4. Crankcase engine oil level lines
To inspect the engine oil level:
• Start the engine and run at idle for
approximately five minutes.
• Stop the engine, then wait for at
least three minutes for the engine
oil to settle.
• Note the engine oil level visible in
the sight glass.
• When correct, engine oil should
be visible in the sight glass at a
point midway between the upper
(maximum) and lower (minimum)
horizontal lines marked on the
crankcase.
126
Caution
stop the engine
investigate
2
Note
An accurate indication of the level of
engine oil in the engine is only shown
when the engine is at normal operating
temperature and the motorcycle is
upright (not on the side stand).
the
• If it is necessary to top off the
engine oil level, remove the filler
plug and add engine oil, a little at a
time, until the level registered in the
sight glass is correct.
• Once the correct level is reached,
install and tighten the filler plug.

Engine Oil and Oil Filter Change

Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis.
Used engine oil contains harmful
contamination that can lead to skin
cancer.
Always
clothing and avoid skin contact with
used oil.
The engine oil may be hot.
Avoid contact with the hot engine
oil by wearing suitable protective
clothing, gloves and eye protection.
Contact with hot engine oil may cause
the skin to be scalded or burned.
The engine oil and filter must be
replaced in accordance with scheduled
maintenance requirements.
Warning
wear suitable
Warning
protective