Table of Contents
Advertisement
AMU-II pH/Redox
Installation
3.10. RS232 Interface
Downloading
SwanTerminal
Establishing a
connection
A-96.150.441 / 230523
The RS232 interface is located on the back of the AMU-II transmitter.
Use the USB to RS232 interface converter available from Swan.
To use the functions provided via the RS232 interface, the
SwanTerminal program is required, which can be downloaded from
www.swan.ch.
To establish a connection between the PC and the AMU-II transmitter,
proceed exactly in the following order:
1 Apply power to the AMU-II transmitter.
2 First connect the interface converter to the USB port of the PC
without the AMU-II connected to the other end of the cable.
3 Wait a few seconds for the interface converter to be detected by
the operating system.
4 Connect the other end of the cable to the pins labeled "COM" on
the back of the AMU-II transmitter. The blue coding pin [A] must
be at the top right corner.
The AMU-II transmitter reboots automatically.
5 Start the SwanTerminal program on the PC and select the
correct COM port.
6 Click the
button in SwanTerminal to connect to the AMU-II
transmitter.
A
29
Advertisement
Table of Contents
