Swann AMU-II ph/Redox Operator's Manual page 50

AMU-II pH/Redox
Error List
Error Description
E001 Alarm high
E002 Alarm low
E007 Sample temp. high
E008
Sample temp. low
E009
Sample flow high
E010 Sample flow low
E011 Temp. shorted
E012 Temp. disconnected
E013
Case temp. high
E014
Case temp. low
E017 Control timeout
E018 Quality assurance
E024 Input active
E026
IC LM75
E030 EEProm frontend
48
Corrective action
– check process
– check programmed value, see
– check process
– check programmed value, see
65
– check process
– check programmed value, see
– check process
– check programmed value, see
66
– check sample flow
– check programmed value, see
– establish sample flow
– clean instrument
– check programmed value, see
66
– check wiring of temperature sensor, see
– check temperature sensor
– check wiring of temperature sensor, see
– check temperature sensor
– check case/environment temperature
– check programmed value, see
– check case/environment temperature
– check programmed value, see
– check control device or programming in
Installation, Relay contact, Relay 1 and 2 see
5.3.2 and 5.3.3, p. 67
– perform QA Procedure using reference
instrument, e.g. AMI Inspector.
– see if Fault = Yes is programmed in menu, see
5.3.4, p. 71
– call service
– call service
5.3.1.1.1, p. 65
5.3.1.1.25, p.
5.3.1.3.1, p. 66
5.3.1.3.25, p.
5.3.1.2.2, p. 66
5.3.1.2.35, p.
, p. 21
, p. 21
5.3.1.4, p. 66
5.3.1.5, p. 66
A-96.150.441 / 230523