Swann AMU-II ph/Redox Operator's Manual page 63

AMU-II pH/Redox
Program List and Explanations
5.2 Signal Outputs
5.2.1 and 5.2.2
5.2.1.1
5.2.1.2
5.2.1.3
A-96.150.441 / 230523
Note: The navigation in the menu <Signal Output 1> and <Signal
Output 2> is identical. For reason of simplicity only the menu
numbers of Signal Output 1 are used in the following.
Signal Output 1 and 2: Assign process value, the current loop
range and a function to each signal output.
Parameter: Assign one of the process values to the signal output.
Available values:
 Meas. Value
 Temperature
 Sample Flow (if a flow sensor is selected)
Current Loop: Select the current range of the signal output. Make
sure the connected device works with the same current range.
Available ranges: 0–20 mA or 4–20 mA
Function: Define if the signal output is used to transmit a process
value or to drive a control unit. Available functions are:
 Linear, bilinear or logarithmic for process values.
See As process values, p. 62
 Control upwards or control downwards for controllers.
See As control output, p. 63
61