Reassembly - Graco GM 5000 Instructions And Parts List

5. Place the engine (64) assembly on the cart. Align
the mounting holes. Guide the engine wire (A)
through the clamp at the the rear of the mounting
plate (25). See~Detail A. Guide the wiring harness
mounting plate (25). Install the serrated flange
(58) from the field, through the grommet (24) in the
screws (63) and nuts
(40)
and torque to 15 ft-lb
(20.4 Nm). Install the capscrews (51), lockwashers
(132) and washer (50) from under the engine
mounting plate to secure the clutch housing (61).
connect the black and white wires of the pressure
Connect the engine wire (A) to the red wire, and
control at B as shown in the Detail A, Fig. 46.
6. Be sure the face of the rotor (55b) and the field (61)
is free of all oil and contaminants. Install the rotor,
capscrews to 7ft-lb (9.5 Nm). See Fig. 46.
lockwashers (59) and capscrews (60). Torque the
Reassembly
After installing the rotor (55b), pull the engine recoil
is no friction between the rotor (55b) and the field
rope to assure that the engine turns freely, and there
(61). If there is friction, loosen the setscrews (62)
and reposition the field (61) as necessary. Tighten
the setscrews oppositely and evenly to 25 in- Ib (2.8
Nm).
Also
make sure there are no burrs on the out-
side edge of the rotor.
7. Be sure the face of the armature (55a) is clean. As-
semble the armature to the shaft in the pinion hous-
ing (C). A retaining ring located within the armature
makes
it
difficult to assemble these parts. For the
best results, first engage a few splines of both parts,
then use a screwdriver to gently push the retaining
ring into the armature, and then engage the remain-
it
contacts the ring.
ing splines. Push the armature onto the shaft until
8.
Assemble the drive/pinlon housing (C) to the
washers (59). See Fig. 46.
clutch housing, using the capscrews (67) and lock-
Torque to 7 ft-lb (9.5
N.m)
A
Faces must be clean
A
Torque to 15ft-lb (20.4
N.m)
MOUNTING PLATE
308-105
39