Verizon FSNO21VA User Manual page 42

BASIC SETTINGS
3. Use one of the following methods:
• If your Wi-Fi client device has a WPS button, press the
WPS button on your Gateway for more than two seconds,
then click the Start WPS
WPS registration process.
• If your client device has a WPS PIN, locate the PIN printed
on the client's label or in the client documentation. Enter
the PIN number in Option 2
• Click Register
• Alternatively, you can enter the Gateway's PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
4. After pressing the WPS button on your Gateway, you have
two minutes to press the WPS button on the client device
before the WPS session times out.
When the WPS button on your Gateway is pressed, the
Status LED on the front of your Gateway begins flashing
blue. The flashing continues until WPS pairing to the client
device completes successfully. At this time, the Status LED
turns solid white.
If WPS fails to establish a connection to a Wi-Fi client device
within two minutes, the Status LED on your Gateway flashes
red for two minutes to indicate the WPS pairing process was
unsuccessful. After flashing red, the light returns to solid
white to indicate that Wi-Fi is on.
Start WPS button in Option 1
Option 2 on the user interface.
Register.
Option 1 to start the