Frequency Step; Amateur Radio Band Selection; Direct Keyboard Frequency Entry - Kenwood TS-450S Instruction Manual

4-11-4. Frequency Step
A. TUNING knob
The frequency step depends on the mode that has been
selected.
Frequency One revolution
Meds Step | of TUNING knob
SSB/CW/FSK 10 Hz 10 kHz
AM/FM 100 Hz 50 kHz
When the FINE function is ON, the frequency step is 1
Hz. The frequency step in the AM and FM modes can
be set to 10 Hz. (Please refer to Section 4-11-15.)
1. The active VFO frequency step is shown below.
Frequency Step One pees ACUINES CH
10 KHz 240 kHz
The frequency step may be reprogrammed.
(Please refer to Section 4-11-15.)
2. This control is also used to select the desired
memory channel during Memory Channel Operation.
4-11-5. | Amateur Radio Bands selection
Press the UP/DOWN switch to change amateur radio bands.
4-11-6. Direct keyboard frequency entry
Direct keyboard entry of the operating frequency is possible using the Numeric Keypad on the transceiver. This
Note
KEY coverage of the radio.
You cannot enter any frequency which is outside the
1. Press the ENT key. The display will indicate.
ENT
'
43