Kenwood TS-450S Instruction Manual page 16

19
katgdaret 4 eal
MEMORY.
MOVEO.
Numeric keypad
When used in conjunction with the ENT key, the
keypad is used to directly enter a frequency.
The keypad also has the folloeingfunctions:
O
8.83 FILTER key
Selects the desired 8.83MHz filter regardless of
mode.
© 455 FILTER key
Selects the desired 455kHz filter regardless of
mode.
RX M key
When this key is pressed during reception, the
dB display turns on and off. The AF level is
displayed on the scale (dB), independent from
the AF volume control setting.
AT TUNE key
When the THRU/AUTO switch is placed in the
AUTO position, the automatic tuner will be
engaged and the tuner will try to match the
antenna.
TONE key
Press this key to turn the repeater Sub audible
tone encoder on.
TX M key
The meter indication during transmission can be
switched as follows.
ALC SWR
—— No indicator a=
AF key
Press this key while pressing TF SET key to
display the offset from the current receiving
frequency.
FINE key
One turn of the tuning knob is made equivalent
to 1kHz (1Hz step) in the SSB,CW, and FSK
modes to facilitate tuning. When the key is
pressed again, the original tuning rate of 10KHz
per revolution returns.
REV key
The BFO uses USB for normal CW reception.
With this key, reception becomes possible on
LSB. The BFO uses LSB for normal FSK
operation. With this key, reception becomes
possible on USB.
@
CLR (Clear) key
Used when reentering memory channel data,
erasing a memory channel, clearing scan, or
when specifying the channels that will be
skipped during scan operations.
20) ENT (Enter) key
Used to directly enter a frequency from the
numeric keypad.
@1) MIN key
Used to enter data into a memory channel.
2) MP VFO key
Used to transfer a frequency from memory to
the VFO.
@3) SCAN key
Pressed during VFO operation will initiate
program scan, and pressed during memory
operation will initiate memory scan.